Caliper Tester

Caliper Tester

Problems bleeding brakes, 01 'Ford E-150?

I replaced everything but the ABS control module and try to solve this problem. The cause this problem, I think that the brake calipers off for a period of 3 hours until I had the opportunity to re-install again. We serve the system enough to pass for a lifetime supply of brake fluid, and I still have a pedal goes directly to the ground. Again, new wheel cylinders, calipers and master cylinder, including all materials have been replaced. We prepared the master cylinder in the vehicle air twice without appearing in the second attempt. Is there a way to vent air from the Command Module ABS without the examiner NGS? Or should I be concerned with the control module of the APA at all? The repair manual says it does not bleed unless the lines connected to it have been replaced or removed, or if the device had to be replaced. Please advise.

Sounds like there is still air trapped in the master cylinder itself what to do is have someone in the vehicle and the dividing lines on the master and kept pressing the pedal to tighten the lines and repeated several times and then one by one and severity of bleeding each wheel, which should help ensure that the rear shoes are set correctly and make sure the stirrups backwards Arent not call stupid, but I've seen Do not try to bleed the ABS unit which will give ua big problem to treat. ensure the absence of leaks at all fittings and clamps cyl.master luck